hi has anybody got a circuit diagram for a Sharp satcan the long one.I've tried some of the circuit diagrams but don't seem to work as anybody got any pictures of their satcan. Thanks

I used to use Amstrad ones back in the day and they were fine this one I can't get any static out of it whatsoever

tried both of these.which one is the right.

and this one

It could be because it doesn't look like there is any tuning voltage being applied to the tuning pin. Has anyone got the datasheet or knows if that schematic is right or wrong?

Looks like the old original sharp cans, very common receivers in rigs from the early to late 90s.

...That Juggling Pirate diagram should be ok? Are you sure you are connecting up the correct pins?

Teckniqs, I noticed that there is a difference between the two diagrams as well.I think the first one is correct because otherwise there would be no power to that 10R resistor.

The Juggling Pirate diagrams were tried and tested before being put on paper, I would be very surprised if Mr Mike 'Vandog' H had got it wrong.

....But it's been at least 23 years since I used one of those satcans, if I still had a wired-up one I'd be more than glad to assist.

Sharp BSFA75G08

Sent from my AMN-LX9 using Tapatalk

The picture was from juggling pirate incase you never saw that it shows it wired up. Big Mike never makes a mistake if he. Does he corrects it before posting so it's sure thing it will work.

Sent from my AMN-LX9 using Tapatalk

Is this what your looking for?

Sent from my AMN-LX9 using Tapatalk

Electronically wrote:Is this what your looking for?

Sent from my AMN-LX9 using Tapatalk

Came across it on ebay

Sent from my AMN-LX9 using Tapatalk

just copied that circuit it work straight away

yeah thanks for remembering the post mate nice one