I've been doing some experiments on an "outphased" AM design. It uses a simple CMOS synthesiser which generates a sinewave at the carrier frequency (digitally generated), then the "outphasing" is achieved by driving a couple of comparators with the sinewave into one input of each comparator, and the modulation and inverted modulation into the others. The output from the comparators is fed to a couple of bistables, which give a wavetrain of square waves, with variable mark / space ratios according to the modulation.... The two logic outputs are amplified by FET amplifiers, and each is fed into an inductor. The inductors meet at their output ends, and there's a capacitor to ground (for resonance). The mixed signals at the combination point equate to AM! There's then a lowpass filter to keep everything clean 'n' green, and the output feeds the antenna directly.

At the moment, the prototype is delivering 60 Watts carrier / 240 Watts peak, and is capable of 125% positive-going mod (just by tweaking the comparator stage). The recovered audio sounds superb - I was concerned that there might be distortion, but these fears proved to be unfounded. Initial listening tests suggest very low percentage distortion, and I'll carry out some actual measurements later.

The beauty of the design is that it can be fully modulated with just a couple of volts of audio. There are no big chokes needed (or modulation transformers), and efficiency is over 90%! It's also reasonably frequency-agile (similar purity over about 220kHz of the MW band). The only minor snag is that the output inductors need to be slightly variable, but I'm considering some kind of variometer to provide this adjustment...

Cicuits to follow shortly.

Morning Albert
I admit I'm not a technical person but is that similar to the Ampliphase RCA transmitters used by Radio Caroline on the Ross Revenge or am i completely barking up the wrong tree.

Sounds great. I always found the MW fascinating because you can really (theoretically) reach a big part of the world with your signal. If I can't - for whatever reason - continue to broadcast on band II (who knows how it will be used in the future as analogue radio stations are slowly getting shut down here) it will either be the MW or the SW for me. SW antennas take up much less space though.

If You have time, can You quickly calculate it to 48m also?

surefm wrote: ↑Fri Oct 25, 2024 9:06 am Morning Albert
I admit I'm not a technical person but is that similar to the Ampliphase RCA transmitters used by Radio Caroline on the Ross Revenge or am i completely barking up the wrong tree.

You're not wrong - it's a bit similar. Ampliphase uses two carriers 135° apart (when unmodulated), and these are amplified and combined in an output "bridge" circuit. The two carriers are phase advanced and retarded in opposing directions, and the combined result is AM. However, unlike my approach, the Ampliphase system requires a lot of envelope feedback to make the audio good enough to listen to! The alignment of those rigs was a "Black Art"!

Unfortunately, RCA Ampliphase proved that RCA stands for "Requires Constant Attention". The reliability of them was often appalling, I had the misfortune to have to maintain a couple of them many years ago.....