Hi guys , I have one of these sets http://dbtec.org/shop/product_info.php?products_id=37 , but not in the normal scheme as that would make it work , can someone of you have used such sets, and he has a scheme?

That's the schematic mine came with on your link and it worked really well when we used it. Works very similar to the Sharp can of similar size but with tracking in-case of link TX drift.

I can not read the component values ​​in the diagram , very low resolution (
can you have a circuit in normal resolution ?

It uses a PIC microcontroller, so unless you have the code the schematic is near useless. What kind of satcan do you have, are you sure it is a digitally controlled one? If it is, you will need to get the datasheet for it so you can see what protocol to use.

I have a tuner and controller of this set .
no schemes that would collect .

Can't you just email them and ask them for it?

I wrote to him on emeil , he does not respond for more than 2 months , therefore I ask you , can someone has circuit ..

Open the can carefully and check what pll chip is inside (most probably ST5055 or TSA5055 or TSA 5511). Then report here so we can suggest controller schematic.

YellowFM wrote:I wrote to him on emeil , he does not respond for more than 2 months , therefore I ask you , can someone has circuit ..

I used to have it, it was sent with the receiver on a piece of A4 paper. If I find it again I'll be sure to let you know but I've got a feeling it's been chucked away.

if you have a scheme , please post it here )

Minitrak schematic
And will look for the normal version
I have cans and chips and thinking of making a kit or module with it

And here the digitrak

Thank you very much , the second scheme is right for me !
And you have the firmware for the controllers ?
I do not for commercial use , for personal use only .

YellowFM wrote: I do not for commercial use , for personal use only .

That's a shame.