Page 1 of 1
10Ghz Microwave Link Receiver Box STL X Band Satcan
Posted: Fri Oct 02, 2015 5:29 pm
by garna86
picked this receiver up recently does this look any to you guys?
Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan
Posted: Sat Oct 03, 2015 12:26 pm
by teckniqs
The voltage drop resistor looks a bit burnt out, could do with a 5v regulator instead.
Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan
Posted: Sun Oct 04, 2015 9:06 am
by garna86
thanks for the quick reply mate, how should i go about fixing the resistor
Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan
Posted: Sun Oct 04, 2015 12:15 pm
by teckniqs
Remove it and use a 7805 regulator instead. Where the red power wire goes on to the sat can, put your regulator + input on to there and your 5v + output to where the resistor was connected to. Obviously the regulator needs to be connected to ground too.
Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan
Posted: Mon Oct 05, 2015 1:41 pm
by garna86
ok wicked mate i will get a new regulator and give it a go